Allied Telesis AT-S62 - Manual (Page 100)

Chapter 10: File Downloads and Uploads
Section II: Advanced Operations 100
7. In the TFTP Local Filename field, enter a name for the file. This is the
name that the switch will store the file as in its file system. If you are
downloading the AT-S62 image file, enter “ats62.img” as the filename.
8. In the TFTP File Type, select one of the following:
❑ Image - Select this option to download a new AT-S62 image file.
❑ Config (set default and reboot) - Select this option to download a
configuration file that is to be designated as the active boot
configuration file on the switch.
❑ File - Select this option to download a CA certificate or a
configuration file that you do not want designated as the active
boot configuration file.
9. Click Apply.
The management software will notify you once the download is
complete.
Caution
If you are downloading a system image file, the switch must
decompress it and write it to flash after it has been downloaded.
This can require one to two minutes to complete. Do not reset or
power off the unit while it is decompressing the file. Once the file
has been decompressed, the switch automatically resets. Your web
browser management session will end. To continue managing the
switch, you must reestablish the management session.
Note
If you downloaded a configuration file using the Config selection,
the switch automatically designates it as the active configuration
file and resets.