Allied Telesis AT-S62 - Manual (Page 208)

Chapter 19: SNMPv3 Protocol
Section III: SNMPv3 Operations 208
Configuring the SNMPv3 SecurityToGroup Table
You can create, delete, and modify an SNMPv3 SecurityToGroup Table
entry. See the following procedures:
❑ Creating a SecurityToGroup Table Entry on page 208
❑ Deleting a SecurityToGroup Table Entry on page 210
❑ Modifying a SecurityToGroup Table Entry on page 211
For reference information about the SNMPv3Configuring the SNMPv3
SecurityToGroup Table on page 208.
Creating a
SecurityToGroup
Table Entry
To create an entry in the SNMPv3 SecurityToGroup Table, perform the
following procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 186.
4. In the SNMPv3 section of the page, click the circle next to Configure
SecurityToGroup Table. Then click Configure at the bottom of the
page.
The SNMPv3 SecurityToGroup Table Page is shown in Figure 68.
Figure 68 SNMPv3 SecurityToGroup Table Page