Allied Telesis AT-S62 - Manual (Page 140)

Chapter 14: Quality of Service
Section II: Advanced Operations 140
Description
Specifies the flow group description. A description can be up to 15
alphanumeric characters, including spaces.
Priority (802.1p)
Specifies a new user priority value for the packets. The range is 0
to 7. If you specify a new user priority value here and in Traffic
Class, the value here overrides the value in Traffic Class. If you
want the packets to retain the new value when they exit the
switch, change Remark Priority to Yes.
Classifier List
The classifiers to be assigned to the flow group. The specified
classifiers must already exist. To select more than one classifier,
hold down the Ctrl key when making your selections.
6. Click Apply.
The management software creates the new flow group.
7. To permanently save your changes, select the Save Config menu
selection.
Modifying a Flow
Group
This procedure explains how to modify an existing flow group. If the
flow group is already part of a QoS policy that is assigned to one or more
switch ports, you must first modify the policy by removing the port
assignments before you can modify the flow group. You can reassign the
ports back to the policy after you have finished modifying the flow
group.
To modify a flow group, perform the following procedure:
1. From the Home Page, select Configuration.
2. Select the Services menu selection.
3. Select the Flow Group tab.
4. Click the dialog circle next to the flow group you want to modify and
click Modify. You can modify only one flow group at a time.