Allied Telesis AT-S62 - Manual (Page 44)

Chapter 3: Basic Switch Parameters
Section I: Basic Operations 44
Pinging a Remote System
You can instruct the switch to ping a node on your network. This
procedure is useful in determining whether a valid link exists between
the switch and another device.
To ping a network device, perform the following procedure:
1. From the Home Page, select Monitoring.
2. From the Monitoring menu, select Utilities.
3. Select the Ping Client tab.
The Ping Client tab is shown in Figure 9.
Figure 9 Ping Client Tab
4. Enter the IP address of the end node you want the switch to ping.
5. Click OK.
The results of the ping are displayed in a popup window.
6. To stop the ping, click OK.