Allied Telesis AT-S62 - Manual (Page 189)

AT-S62 Web Browser Interface User’s Guide
Section III: SNMPv3 Operations 189
5. Click the Add button to add a new SNMPv3 User Table entry.
The Add New SNMPv3 User Page is shown in Figure 60
Figure 60 Add New SNMPv3 User Page
6. In the User Name field, enter a name, or logon id, that consists of up
to 32 alphanumeric characters
7. In the Authentication Protocol field, enter an authentication protocol.
This is an optional parameter.
Select one of the following:
MD5
This value represents the MD5 authentication protocol. With this
selection, users are authenticated with the MD5 authentication
protocol after a message is received. With this selection, you can
configure a Privacy Protocol.
SHA
This value represents the SHA authentication protocol. With this
selection, users are authenticated with the SHA authentication
protocol after a message is received. With this selection, you can
configure a Privacy Protocol.
None
This value represents no authentication protocol. When messages
are received, users are not authenticated. With the None
selection, you cannot configure a Privacy Protocol.
8. In the Authentication Password field, enter an authentication
password of up to 32 alphanumeric characters.