Allied Telesis AT-S62 - Manual (Page 101)

AT-S62 Web Browser Interface User’s Guide
Section II: Advanced Operations 101
Uploading a File
This procedure explains how to upload a file from the switch’s file
system to a TFTP server on your network using the web browser
interface. You can upload any of the following files:
❑ Boot configuration file
❑ Public encryption key
❑ CA certificate
❑ CA enrollment request
❑ Event log file
Note
The public key, CA certificate, and CA enrollment request are only
supported on the version of AT-S62 management software that
features SSL, PKI, and SSH security.
Note the following before you begin this procedure:
❑ You must use TFTP to upload a file using a web browser
management session.
❑ There must be a node on your network that contains the TFTP
server software.
❑ You should start the TFTP server before you begin the upload
procedure.
❑ The switch from which you are uploading a file must have an IP
address and subnet mask, such as a master switch of an enhanced
stack. You cannot use TFTP on a slave switch, since that type of
switch typically does not have an IP address. Rather, you would
need to perform the upload from a local management session of
the switch using Xmodem. For instructions, refer to the AT-S62
Menus Interface User’s Guide.
To upload a file, perform the following procedure:
1. From the Home Page, select Configuration.
2. Select the Utilities menu option.
3. Select the System Utilities tab.
The System Utilities tab is shown in Figure 28 on page 99.