Allied Telesis AT-S62 - Manual (Page 222)

Chapter 19: SNMPv3 Protocol
Section III: SNMPv3 Operations 222
Modifying Target
Address Table
Entry
To modify an entry in the SNMPv3 Target Address Table, perform the
following procedure.
1. FFrom the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 186.
4. In the SNMPv3 section of the page, click the circle next to Configure
Target Address Table. Then click Configure at the bottom of the
page.
The SNMPv3 Target Address Table Page is shown in Figure 74 on
page 219.
5. Display the Target Address Table entry that you want to change.
Click Next or Previous to display an entry.
6. Click Modify.
The Modify SNMPv3 Target Address Table Page is shown Figure
76.
Figure 76 Modify SNMPv3 Target Address Table Page
7. In the IP Address field, enter the IP address of the host.
Use the following format for an IP address:
XXX.XXX.XXX.XXX
8. In the UDP Port Number field, enter a UDP port number.