Allied Telesis AT-S62 - Manual (Page 201)

AT-S62 Web Browser Interface User’s Guide
Section III: SNMPv3 Operations 201
Configuring the SNMPv3 Access Table
You can create, delete, and modify an SNMPv3 Access Table entry. See
the following procedures:
❑ Creating an Access Table on page 201
❑ Deleting an Access Table Entry on page 204
❑ Modifying an Access Table Entry on page 206
For reference information about the SNMPv3 Access Table, see
Configuring the SNMPv3 Access Table on page 201.
Creating an
Access Table
To create an entry in the SNMPv3 Access Table, perform the following
procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab. The SNMP Tab is shown in Figure 58 on page
186.
4. In the SNMPv3 section of the page, click the circle next to Configure
Access Table. Then click Configure at the bottom of the page. The
SNMPv3 Access Table Page is shown in Figure 65.
Figure 65 SNMPv3 Access Table Page