Allied Telesis AT-S62 - Manual (Page 244)

Chapter 19: SNMPv3 Protocol
Section III: SNMPv3 Operations 244
Displaying Target
Parameters Table
Entries
To display entries in the SNMPv3 Target Parameters Table, perform the
following procedure.
1. From the Home Page, select Monitoring.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
4. From the SNMP Monitoring Tab, click the circle next to the View
Target Parameters Table.
5. Click View at the bottom of the page.
The Monitoring, SNMPv3 Target Parameters Table Page is shown
in Figure 88.
Figure 89 Monitoring, SNMPv3 Target Parameters Table Page