Allied Telesis AT-S62 - Manual (Page 104)

Chapter 11: Event Log and Syslog Servers
Section II: Advanced Operations 104
Managing the Event Log
The event log contains event messages that are generated by a switch.
These events can provide vital information about network activity on an
AT-8500 Series switch that can help you identify and solve network
problems. The information includes the time and date when an event
occurred, the event’s severity, the AT-S62 module that generated the
event, and an event description.
The following procedures explain how to view the events in the event
log as well as how to enable or disable the log. Procedures include:
❑ Enabling or Disabling the Event Log on page 104
❑ Displaying the Event Log on page 106
❑ Modifying the Event Log Full Action on page 110
❑ Saving the Event Log on page 111
❑ Clearing the Event Log on page 111
Enabling or
Disabling the
Event Log
This procedure explains how to enable or disable the event log on the
switch. If you disable the log, the AT-S62 management software will not
store events in its log and will not send events to any syslog servers you
might have defined. The default setting for the event log is enabled.
The event log, even when disabled, will log all AT-S62 initialization
events that occur whenever the switch is reset or power cycled. Any
switch events that occur after AT-S62 initialization are entered into the
log only if it is enabled.
Note
Allied Telesyn recommends setting the switch’s date and time if you
enable the event log. Otherwise, the entries entered in the log and
sent to a syslog server will not have the correct date and time. For
instructions, refer to Setting the System Time on page 41.
To enable or disable the event log on a switch, do the following:
To enable or disable the event log, do the following:
1. From the Home Page, select Configuration.
2. Select the System menu option.
3. Select the Event Log tab.