Allied Telesis AT-S62 - Manual (Page 132)

Chapter 13: Access Control Lists
Section II: Advanced Operations 132
selections. To view the classifiers on a switch, refer to Displaying
the Classifiers on page 128. An ACL must have at least one
classifier.
Action
Use this menu to specify the action of the ACL. Deny, which is the
default, discards ingress packets that match the defined traffic
flow of the classifier. Permit accepts the packets. The default is
Deny.
Description
Use this field to enter a description for the ACL. A description can
be up to 15 alphanumeric characters, including spaces. A
description is optional.
Port List
Use this list to specify the port where you want to assign the ACL.
You can assign an ACL to more than one port. To select multiple
ports, hold down the Ctrl key while making your selections. You
do not have to assign an ACL to a port when you initially create it.
However, an ACL that is not assigned to any port is considered
inactive.
6. After you have finished configuring the parameters, click Apply.
The new ACL is immediately activated on the specified ports. If
you did not specify any ports for the ACL, the ACL is created but
remains inactive until you assign it to a port.
7. To permanently save your changes, select the Save Config menu
selection.