Allied Telesis AT-S62 - Manual (Page 323)

AT-S62 Web Browser Interface User’s Guide
Section VII: Management Security 323
IP Address and Server Secret
Use these fields to specify the IP addresses and encryption
secrets of up to three network servers containing TACACS+
server software. You can leave an encryption field blank if you
entered the server’s secret in the Global Secret field.
c. When you are finished configuring the parameters, click Apply.
d. To enable the authentication feature on the switch, click the
Enable Server-based Authentication check box. A check in the box
indicates that this feature is enabled. No check indicates the
feature is disabled. The default is disabled.
e. To permanently save the changes, use the Save Changes button
in the General tab. For directions, refer to Saving Your Parameter
Changes on page 23.
7. To configure RADIUS, do the following:
a. In the bottom part of the Server-based Authentication tab, click
RADIUS Configuration and click Configure.
The RADIUS Client Configuration page is shown in Figure 117.
Figure 118 RADIUS Configuration Page
b. Configure the parameters as needed. They are described below.
Global Encryption Key
If all of the RADIUS servers have the same encryption secret,
you can enter the key here. If the servers have different keys,
you must specify each key when you specify a server’s IP
address.