Boonton 4500B Peak Power Meter - Manual (Page 32)

Boonton 4500B RF Peak Power Analyzer
Installation 2-4
7. Verify that the message ―Channel 1 is installed (Rev _._)‖ appears. If a sensor is plugged into channel 1,
the phrase ―with Sensor Connected" will also appear. A phrase indicating the sensor cable length
expected may also be appended.
8. If the optional second channel is installed and a sensor is connected to it, a similar message should
appear for Channel 2.
Note If the display does not appear or differs significantly from the illustrated display, try
reinstalling the instrument software as described in Section 7.5 "Software Upgrade". If this
does not correct the problem, contact Boonton Electronics for technical support.
Figure 2-2. Power-On Display