Boonton 4500B Peak Power Meter - Manual (Page 277)

Boonton 4500B RF Peak Power Analyzer
Remote Operation 5-77
STATus:QUEStionable:CONDition?
Description: Return the current value (condition) of the SCPI Questionable Status register. The following
table shows the bit assignments in the register:
Bit Value Definition
0 1 Voltage 1 = an internal power supply voltage is out of spec.
1 –3 -- Not used always 0.
4 16 Temperature 1 = sensor temperature drift (see note below).
5 - 12 -- Not used always 0.
8 256 Calibration 1 = sensor requires calibration and/or zeroing
9 - 15 -- Not used always 0.
Note: For temperature compensated sensors with Temp Comp
―On‖, warning occurs for greater than ±30 degrees C from
auto-cal temperature. For non-compensated sensors or Temp
Comp ―Off‖, warning occurs for greater than ±4 degrees C.
Syntax: STATus:QUEStionable:CONDition?
Returns: 16-bit register value (0 to 32767)
Valid Modes: Any
STATus:QUEStionable:ENABle
Description: Sets or returns the enable mask which allows true conditions in the Questionable Status Event
register to be reported in the summary bit. If a bit is 1 in the Questionable Enable register and its
associated event bit transitions to true, a positive transition will occur in the Questionable Status
summary bit.
Syntax: STATus:QUEStionable:ENABle
Argument: = 0 to 32767
Valid Modes: Any
STATus:QUEStionable:EVENt?
Description: This query returns the contents of the Questionable Event register.
Syntax: STATus:QUEStionable:EVENt?
Returns: 16-bit register value (0 to 32767)
Valid Modes: Any