Boonton 4500B Peak Power Meter - Manual (Page 306)

Boonton 4500B RF Peak Power Analyzer
Remote Operation 5-106
Table 5-1. SCPI COMMAND SUMMARY (continued)
SENSe[3|4]:IMPedance
Set/return trigger impedance. = 1, 50 (1Mohm or 50 Ohm)
SENSe:NORMalize
Set/return distribution function normalization. = ON, OFF
SENSe[1|2|3|4|6|7]:PULSe:DISTal
Set/return distal parameter of the risetime. = 20.00 to 99.00
SENSe[1|2|3|4|6|7]:PULSe:ENDGT
Set/return pulse gate end position in percent of pulse time
duration. = 60.00 to 100.00
SENSe[1|2|3|4|6|7]:PULSe:MESIal
Set/return mesial parameter of the risetime. = 10.00 to 90.00
SENSe[1|2|3|4|6|7]:PULSe:PROXimal
Set/return proximal parameter of the risetime. = 0.10 to 30.00
SENSe[1|2|3|4|6|7]:PULSe:STARTGT
Set/return pulse gate start position in percent of pulse time
duration. = 0.00 to 40.00
SENSe[1|2|6|7]:PULSe:UNIT
Set/return pulse definitions units. = WATTS, VOLTS
SENSe[3|4]:RANGe
Set/return trigger range. = 5 50
STATus:OPERation:CONDition?
Return value of Operation Condition Register
STATus:OPERation:ENABle
Set/return value of Operation Enable Mask
STATus:OPERation:EVENt?
Return value of Operation Event Register
STATus:OPERation:NTRansition
Set/return the negative transition filter
STATus:OPERation:PTRansition
Set/return the positive transition filter
STATus:PRESet
Set device dependent SCPI registers to default states
STATus:QUEStionable:CONDition?
Return value of Questionable Condition Register
STATus:QUEStionable:ENABle
Set/return value of Questionable Enable Mask
STATus:QUEStionable:EVENt?
Return value of Questionable Event Register
STATus:QUEStionable:NTRansition
Set/return the negative transition filter
STATus:QUEStionable:PTRansition
Set/return the positive transition filter
SYSTem:AUTOSET
Perform AutoSetup
SYSTem:BEEP
Set/return keypad audible beeper status. = ON, OFF
SYSTem:COMMunicate:GPIB:EOI
Set/return EOI. = ON, OFF