Boonton 4500B Peak Power Meter - Manual (Page 308)

Boonton 4500B RF Peak Power Analyzer
Remote Operation 5-108
Table 5-1. SCPI COMMAND SUMMARY (continued)
TRIGger:BTRIGger:MODE
Select B trigger mode. = OFF, TDLY, EDLY
TRIGger:BTRIGger:SLOPe
Set the B trigger slope of the pulse signal. = POS, NEG
TRIGger:BTRIGger:SOURce
Select B trigger source channel. = CH1, TRIG1, CH2, TRIG2
TRIGger:BTRIGger:TDLY
Set B trigger Time Delay. = 0 to 10000e-3 sec
TRIGger:CDF:COUNt
Set/return statistical mode terminal count. = 2 to 4096
TRIGger:CDF:DECImate
Set/return perform decimation when terminal count is reached. =
ON, OFF
TRIGger:CDF:TIMe
Set/return statistical mode terminal time. = 0 to 3600 sec
TRIGger:DELay
Set/return trigger delay with respect to the trigger. = see
Specifications Section 1-6.
TRIGger:FASTtrig
Set/return fast trigger. = ON, OFF
TRIGger:HOLDoff
Set/return trigger holdoff time. = 0 to 1 sec in 10 nsec increments
TRIGger:LEVel
Set/return trigger level. = -39.99 to 20.00 dBm
TRIGger:MODE
Set/return trigger mode on display. = AUTOPKPK, AUTO,
NORMAL, FREERUN
TRIGger:MODUlated:MODE
Set/return modulated trigger mode on display. = FREERUN,
TRIGGERED
TRIGger:POSition
Set/return trigger position on display. = LEFT, MIDDLE,
RIGHT
TRIGger:SLOPe
Set/return trigger slope on display. = POS, NEG
TRIGger:SOURce
Select trigger source. = CH1, CH2, TRIG1, TRIG2
TRIGger:STATistical:GATE[1|2]
Set/return marker time relative to the trigger. Enter time in seconds.
(Ex: enter 1ms as 0.001)
TRIGger:STATistical:GATIng
Set/return statistical gating to FreeRun (OFF) or Pulse Gated (ON).
= ON, OFF