Boonton 4500B Peak Power Meter - Manual (Page 226)

Boonton 4500B RF Peak Power Analyzer
Remote Operation 5-26
DISPlay:PARAmeter:TOP:RIGHt
Description: Set or return the auto-measure or fixed parameter displayed in the Top row, Right column of the
nine element parameter field above the trace box. The selected parameter will be for the currently
active channel. See DISPlay:ACTive command. DISPlay:PARAmeter:MODE must be set to
MEAS.
Syntax: DISPlay:PARAmeter:TOP:RIGHt
Argument: See Display Parameter Table below
Valid Modes: Pulse Mode only. Note: Modulated mode does not display Status and Measurement parameters.
Statistical mode displays a fixed combination of status and auto-measure parameters.
DISPLAY PARAMETER TABLE
function {
PWIDTH Pulse width
RISETIME Risetime
FALLTIME Falltime
PERIOD Period *
PRFREQ Pulse repetition frequency *
DUTY Duty cycle *
OFFTIME Pulse offtime *
PEAK Peak Power
PULSE Pulse Power *
OVRSHT Pulse overshoot
AVGPWR Average power
TOPPWR Pulse top level power
BOTPWR Pulse bottom level power
SKEW Trigger skew
EDGEDLY Edge delay
FREQ Measurement frequency setting
VIDBW Sensor video bandwidth setting
AVG Channel averaging value
TRA A Trigger slope, source and level
TRB B Trigger slope, source and level or off
TRDLY Trigger delay setting
VSCALE Vertical scale setting
CENTER Vertical center setting
OFFSET } Vertical offset setting
* at least one complete waveform cycle must be displayed