Boonton 4500B Peak Power Meter - Manual (Page 291)

Boonton 4500B RF Peak Power Analyzer
Remote Operation 5-91
TRIGger:BTRIGger:SLOPe
Description: Set or return the B trigger slope or polarity. When set to POS, B triggers will be generated when a
signal‘s rising edge crosses the B trigger level threshold. When NEG, B triggers are generated on
the falling edge of the pulse.
Syntax: TRIGger:BTRIGger:SLOPe
Argument: = {NEG, POS}
Valid Modes: Pulse and gated Statistical modes only
TRIGger:BTRIGger:SOURce
Description: Set or return the trigger source used for the B trigger. The CH1 and CH2 (dual channel models
only) settings use the signal from the associated sensor. TRIG1 and TRIG2 (dual channel models
only) use the signal applied to the associated external trigger input.
Syntax: TRIGger:BTRIGger:SOURce
Argument: = {CH1, CH2, TRIG1, TRIG2}
Valid Modes: Pulse and gated Statistical modes only
TRIGger:BTRIGger:TDLY
Description: Set or return the B trigger arming delay time in seconds with respect to the trigger. Active only
when TRIGger:BTRIGger:MODE is set to TDLY.
Syntax: TRIGger:BTRIGger:DELay
Argument: = 0.0 – 1.0 seconds in 10 nsec increments
Valid Modes: Pulse and gated Statistical modes only