Boonton 4500B Peak Power Meter - Manual (Page 280)

Boonton 4500B RF Peak Power Analyzer
Remote Operation 5-80
5.5.16 SYSTem Subsystem
The SYSTem group of commands is used to control system-level functions not directly related to instrument measurement
performance. SYSTem commands are used to return error codes or messages from the power analyzer error queue, control
hardware features (backlight and key beep), set the command language, and configure communication parameters for the
GPIB and serial interfaces.
SYSTem:AUTOSET
Description: Perform the Auto Setup function to acquire a signal and display the trace in the Pulse mode.
Syntax: SYSTem:AUTOSET
Argument: None
Valid Modes: Pulse mode is forced if not already set.
SYSTem:BEEP
Description: Set or return the status of the audible keyboard beeper.
Syntax: SYSTem:BEEP
Argument: = {ON, OFF}
Valid Modes: Pulse mode is forced if not already set.
SYSTem:COMMunicate:GPIB:EOI
Description: Set or return the 4500B as TALKER EOI control parameter.
Syntax: SYSTem:COMMunicate:GPIB:EOI
Argument: = {ON, OFF}
Valid Modes: Any