HP Integrity NonStop H-Series - Manual (Page 71)

> logon 255.255
password:
2. Make ZDSMSCM the current subvolume:
> VOLUME $volume.ZDSMSCM
3. Check that TMF is running:
> TMFCOM START TMF
4. Check that DSM/SCM is not running:
> RUN STOPSCM
For more information, see “Starting and Stopping DSM/SCM” (page 38) .
5. Run INITENV:
> RUN INITENV
Use this checklist as a quick guide to reinitialize a host or physical target system. The right column
provides common entries and actions to perform for a NonStop system that is network connected,
uses Winsock, and has the ZDSMSCM subvolume located on $DSMSCM. For more information,
see
“Configuring a Host or Target System” (page 50) .
Table 4-4 Reinitialization Checklist
Yes or No Would you like to read the introduction? ___
I Are you changing or initializing the system? ___
Choose to reinitialize to:
• Change a target system to a host system
• Change the TMF volume or the SQL system catalog volume
• Initialize after reinstalling DSM/SCM because of an operational error
Y Database will be destroyed, continue? ___
Destroying the host database, target database, and archive is necessary to
reinitialize, so confirm it.
Host or Target Host or physical target system? ___
The default is to configure the system as a host.
If initializing a host system or a physical target system:
NOTE: The following steps apply for both host system and physical target,
except where noted.
Winsock Winsock or RSC? ___
Winsock is the default. Use the default. INITENV then asks you to provide this
information:
• Volume for SERVICES and PORTCONF files
• Host Database Volume
The default volume is $DSMSCM. Use the default or specify the name of the
volume that contains the host database. The volume must be audited by TMF.
• IP Port Number
Yes Configure Winsock server? ___
$DSMSCM Database volume? This volume must be audited by TMF. ___
Enter, to accept default Volume for SERVICES and PORTCONF files? ___
1089 IP Port Number? (DSM/SCM Planner Interface) ___
The default IP port on the PC for the Planner Interface is 1089. The Planner
Interface is needed on a PC that will use CNFGINFO (not supported on 64-bit
PCs). The location of the Winsock SERVICES and PORTCONF files, and the IP
port number to use. If you do not use the default, you must use an unused number
between 1025 and 65535.
No Compress files? If disk space is limited, enter yes. ___
Managing the NonStop Software Management Configuration 71