Applying a software configuration to a clone group, Creating a clone group software configuration – HP Integrity NonStop H-Series User Manual
Page 175
On the Configuration Revisions page, that target (\PUBS in the example below) is now identified
as a clone in Clone Group 1, with \SCUBA configured as the Master of Clone Group 1.
Applying a Software Configuration to a Clone Group
Most of the process for applying a new software configuration to a clone group is similar to the
normal NonStop Software Essentials process.
CAUTION:
Any software configuration installed for a clone group is indicated in the NonStop
Software Essentials interface only on the master target. NonStop Software Essentials does not
indicate that the clones have the newly installed configuration. Therefore, configuration information
for clones might not appear current.
Creating a Clone Group Software Configuration
To create a new software configuration for a clone group, create a new software configuration
for the master target.
•
SUTs copied to the clone group configuration choose licensed products based on the master
target CUSTFILE.
•
In NonStop Software Essentials displays, only the master indicates that the configuration exists;
the clones do not indicate it.
When you finish creating the new software configuration, click Build/Apply..
Applying a Software Configuration to a Clone Group
175