Add like target – HP Integrity NonStop H-Series User Manual
Page 68
4.
After providing the necessary input in the Main, Output, and SYSGEN tabs, click OK to add
the new logical target. The name of the new logical target appears in the Configuration
Revisions window with a revision number of either 1 or blank (no value), if this is a new
physical target that has just been added, is uninitialized, and has no revisions.
, as necessary, you can build and apply the initial revision for
this logical target, as described in
“Primary Build and Apply Process” (page 109)
Add Like Target
Initiated by clicking the Add Like button, this action is enabled only when a single target revision
is selected in the table. This action brings up a popup window similar to the Add Target popup
except that the input fields are pre-populated with the settings configured for the existing target
that was selected when performing the action. You must change either the Physical Target or Logical
Target name. Make any other desired changes to the input fields on the three tabs (as described
under “Add Target”), then click OK to add the target.
68
Configuring the NonStop Software Management Environment