Changing default parameters – HP Integrity NonStop H-Series User Manual

Page 60

Enter the operator’s user ID or alias; then press F2 to check information about the
operator. To grant a permission, enter Y in its data field. To deny a permission, enter
N in its data field.

By default, each operator has full permission for ZPHITI access. To apply restrictions,
set the appropriate flags on the Operator Security screen.

When all permissions are set, press Shift-F2 if you are updating an existing operator
or F7 if you are adding an operator.

•

To check the security information for an operator, enter the operator’s user ID or alias;
then press F2. To check information about the next operator in the list, press F3. If more
than one page of operators exists, make any changes before pressing F3 to check
additional operators.

•

To delete the operator, enter the operator’s user ID or alias; then press F6. DSM/SCM
removes the operator from DSM/SCM.

After you have finished, press F16 twice to return to the main menu.

Managing the NonStop Software Management Configuration

•

“Changing Default Parameters” (page 60)

•

“Managing Logical Targets” (page 62)

•

“Creating an Alternate System Disk” (page 70)

•

“Reinitializing DSM/SCM” (page 70)

Changing Default Parameters

You can use NonStop Software Essentials or the various DSM/SCM interfaces to change the default
values.

Table 4-2 (page 60)

lists the interface and function to use to change a particular value.

Table 4-2 Changing Default Parameters

By...

Interface

To change...