HP Integrity NonStop H-Series - Manual (Page 63)

Table 4-3 (continued)
Definition State Values
The date and time that the revision was applied on the target. Date, time
There are no revisions for that target. No Revisions
The row is blank (no value) when the row is for a Clone. (blank)
The word “Uninitialized” appearing before any of those values indicates that the target
has not yet been initialized. Uninitialized
To the right of the table on the Configuration Revisions page are the actions that can be performed
on this page. The actions enabled depend on the state of the target or targets selected in the table,
and fall under these categories:
• “New Revision Actions” (page 63)
• “Target Maintenance Actions” (page 64)
• “Software Audit Action” (page 70)
New Revision Actions
Actions under the “New Revision” heading on the Configuration Revisions page are enabled only
when a single target is selected in the table; the action(s) enabled depend on the type of revision
listed for the selected target:
• If the revision for the selected target is a New revision, the available actions are Edit and
Delete.
• If the revision for the selected target is not a new revision, the only available action is Create.
Managing the NonStop Software Management Configuration 63