HP Integrity NonStop H-Series - Manual (Page 49)

received from the planner, the operator initiates tasks on the target system. Therefore, the operator
needs only a minimal understanding of and experience with software installation procedures and
software management operation.
Operator tasks include:
• Initiating the application of the activation package received from the host on tape if the host
and target systems are not connected using Expand
• Activating the software in the activation package (including running OSM or SCF) and, if
necessary, running ZPHIRNM and performing a system load
• Mounting tapes when instructed by EMS messages, TAPECOM, or the ZPHITI status screen
• Monitoring the status of target system tasks
• Requesting an independent snapshot of the target system, to send target system information
to the host database if the host and target systems are not connected using Expand
You can give permission to a operator to perform these functions:
Definition Activity
Apply an activation package. Apply an Activation Package
Back out a configuration. (The default is to deny permission.) Backout a Configuration
Request a snapshot of the system. Request a Snapshot
Request an audit of the system. (The default is to deny
permission.) Request an Audit
Request a system report. Request a System Report
Request a verification of the software database. Verify the Database
Enable a DSM/SCM trace. Enable Trace
Guidelines for Assigning Security Settings 49