HP Integrity NonStop H-Series - Manual (Page 36)

INITENV Tool
When you receive a new NonStop S-series system or Integrity NonStop system, HP has already
initialized DSM/SCM and set up a default configuration. You can use INITENV to change some
DSM/SCM configuration settings or to reinitialize DSM/SCM because of a corrupted database.
You must be super ID (255,255) to run INITENV. If you try to perform an INITENV task that you
do not have permission to perform, INITENV stops, and you must restart INITENV using an
appropriate user ID.
• When you receive a new system, you run INITENV with the change option to change a few
DSM/SCM configuration settings. See
“Task 1: Changing Default Settings Using INITENV”
(page 51) .
• To use INITENV to reinitialize DSM/SCM because of a corrupted database or other problems,
see
“Reinitializing DSM/SCM” (page 70) .
Starting INITENV
1. Check that DSM/SCM is not running. See “Starting and Stopping DSM/SCM” (page 38) .
2. Check that you are in the ZDSMSCM volume:
> VOLUME $vol.ZDSMSCM
vol is the volume containing the DSM/SCM TSV.
NOTE: If you are using multiple logical targets on a system, always run DSM/SCM from
the first ZDSMSCM subvolume installed on the target system, from which INITENV was run,
to ensure that the correct installation files are used. You can also run STOPSCM from the same
ZDSMSCM subvolume if DSM/SCM has finished processing all of its tasks.
3. Run the INITENV tool:
> RUN INITENV
To use INITENV to change only the host name for a target system:
> RUN INITENV CHANGE-HOST new-host
new-host
is the name of the new host name for the target system.
Configuration Verification
As its last step, INITENV automatically runs STARTSCM (which is required by VERIFYI), then runs
VERIFYI to verify the configuration update. VERIFYI
• Checks the INITSTAT file to verify that all setup functions completed successfully
• Confirms that all processes required by DSM/SCM are currently running
• Reminds you to run the ZPHIHMI and ZPHITMI to initialize the DSM/SCM host and target
databases
If VERIFYI detects INITENV errors, a message is displayed for any step not completed, and INITENV
terminates. For more information on corrective action, see the message or the INITENV messages
in the DSM/SCM Messages Manual.
Although you can run manually to VERIFYI any time after INITENV finishes, it is usually not necessary.
INITENV always runs VERIFYI as it’s last step. To run VERIFYI manually:
1. Start DSM/SCM. For more information, refer to “Starting and Stopping DSM/SCM” (page 38) .
2. Run VERIFYI. For example:
> RUN VERIFYI
36 NonStop Software Management Interfaces and Tools