GW Instek PEL-3000 Series Programming Manual - Manual (Page 98)

PEL-3000 Programming Manual
96
Example :POWer:T2 0.200
Sets the T2 timer time to 200ms.
Query example :POWer:T2?
>0.200
Returns the T2 timer time as 200ms.
:POWer:FREQuency
Set
Query
Description Sets the CP dynamic mode switching frequency.
This command along with the “:POWer:Duty”
command is used when the dynamic time setting
is set to “Freq./Duty”.
This command is only applicable for dynamic
mode.
Syntax :POWer:FREQuency { | MINimum | MAXimum}
Query Syntax :POWer:FREQuency?
Related
Commands :POWer:DUTY
Parameter Sets the switching
frequency in hertz.
MINIMUM or MIN Minimum frequency
MAXIMUM or MAX Maximum frequency
Return parameter Returns the frequency in
hertz.
Example :POWer:FREQuency 60
Sets the frequency to 60Hz.
Query example :POWer:FREQuency?
>60
Returns the switching frequency (60Hz).