GW Instek PEL-3000 Series Programming Manual - Manual (Page 88)

PEL-3000 Programming Manual
86
Query example :CURRent:T1?
>0.200
Returns the T1 timer time as 200ms.
:RESistance:T2
Set
Query
Description Sets the T2 timer settings for the CR dynamic
mode.
Syntax :RESistance:T2 {[s] | MINimum | MAXimum}
Query Syntax :RESistance:T2?
Related
Commands :RESistance:T1
Parameter [s] T2 timer setting in
seconds
MINIMUM or MIN Minimum time
MAXIMUM or MAX Maximum time
Return parameter Returns the T2 timer time
in seconds.
Example :RESistance:T2 0.200
Sets the T2 timer time to 200ms.
Query example :RESistance:T2?
>0.200
Returns the T2 timer time as 200ms.
:RESistance:FREQuency
Set
Query
Description Sets the CR dynamic mode switching frequency.
This command along with the
“:RESistance:DUTY” command is used when the
dynamic time setting is set to “Freq./Duty”.
This command is only applicable for dynamic
mode.
Syntax :RESistance:FREQuency { | MINimum |
MAXimum}