GW Instek PEL-3000 Series Programming Manual - Manual (Page 83)

COMMNAND OVERVIEW
81
Syntax :RESistance:SRATe { | MINimum | MAXimum}
Query Syntax :RESistance:SRATe?
Parameter Sets the slew rate in
mA/us
MINIMUM or MIN Set to the lowest slew rate
MAXIMUM or MAX Set to the highest slew rate
Return parameter Returns the slew rate in
mA/us.
Example :RESistance:SRATe MIN
Sets the slew rate to the minimum.
Query example :RESistance:SRATe?
>5.0000
Returns the slew rate as 5mA/us.
:RESistance:L1
Set
Query
Description Sets or queries the CR mode “Level1”
conductance. This command is only applicable to
dynamic mode.
Note: A different value can be set for each current
range (High/Mid/Low).
Syntax :RESistance:L1 {[ MHO ] | MINimum |
MAXimum }
Query Syntax :RESistance:L1?
Parameter
[ MHO ] “level1” conductance
value (CR Unit: MHO )
MINIMUM or MIN Minimum conductance
level
MAXIMUM or MAX Maximum conductance
level
Return parameter Returns the “level1”
conductance value.
Example :RESistance:L1 MIN
Sets the conductance value to the minimum.