GW Instek PEL-3000 Series Programming Manual - Manual (Page 93)

COMMNAND OVERVIEW
91
Power Subsystem Commands
:POWer[:VA] ......................................................................... 91
:POWer:VB............................................................................ 92
:POWer:L1 ............................................................................. 92
:POWer:L2 ............................................................................. 93
:POWer:SET ......................................................................... 93
:POWer:LEVel ...................................................................... 94
:POWer:T1 ............................................................................ 95
:POWer:T2 ............................................................................ 95
:POWer:FREQuency ........................................................... 96
:POWer:DUTY ..................................................................... 97
:POWer[:VA]
Set
Query
Description Sets or queries the CP mode “A Value” power.
This command is applicable to static mode only.
Note: A different “A Value” can be set for different
current ranges.
Note: The [:VA] node can only be omitted when in
static mode.
Syntax :POWer[:VA] {[ W ] | MINimum | MAXimum }
Query Syntax :POWer[:VA]?
Parameter [ W ] “A Value” power value
MINIMUM or MIN Minimum power level
MAXIMUM or MAX Maximum power level
Return parameter Returns the “A Value”
power value.
Example :POWer:VA MIN
Sets the power value to the minimum.
Query example :POWer:VA?
>10W
Returns the “A Value” power setting.