beautypg.com

Configure subsystem commands, Configure]:ocp – GW Instek PEL-3000 Series Programming Manual User Manual

Page 43

background image

COMMNAND OVERVIEW

41

Configure Subsystem Commands

[:CONFigure]:OCP .............................................................. 41

[:CONFigure]:OPP ............................................................... 42
[:CONFigure]:UVP............................................................... 43

[:CONFigure]:OVP .............................................................. 43
[:CONFigure]:SSTart ............................................................ 44

[:CONFigure]:VON ............................................................. 45
[:CONFigure]:VDELay ........................................................ 45

:CONFigure:RESPonse ....................................................... 46
[:CONFigure]:CNTime ........................................................ 46

[:CONFigure]:COTime ........................................................ 47
[:CONFigure]:CRUNit ......................................................... 48

:CONFigure:DYNamic ........................................................ 48
:CONFigure:MEMory .......................................................... 49

:CONFigure:SHORt............................................................. 49
[:CONFigure]:GNG:SPECtest ........................................... 50

[:CONFigure]:GNG:DTIMe .............................................. 50
[:CONFigure]:GNG:MODE .............................................. 51

[:CONFigure]:GNG[:PASS] ................................................ 51
[:CONFigure]:GNG:H ........................................................ 52

[:CONFigure]:GNG:L ......................................................... 52
[:CONFigure]:GNG:C ......................................................... 53

[:CONFigure]:OCP

Set

Query

Description

Sets or queries the OCP trip settings. The OCP
limit can be set to a specific value or the trip setting
can be set to either limit the current or to turn the
load off.

Syntax

[:CONFigure]:OCP {[ A ] | MINimum |
MAXimum | LIMit | LOFF }

Query Syntax

[:CONFigure]:OCP?

Parameter

[A]

Current limit value.