GW Instek PEL-3000 Series Programming Manual - Manual (Page 129)

COMMNAND OVERVIEW
127
Utility Commands
:UTILity:SYSTem? ............................................................. 127
:UTILity:LOAD .................................................................. 127
:UTILity:LOAD:MODE ................................................... 128
:UTILity:LOAD:RANGe .................................................. 129
:UTILity:INTerface ............................................................ 130
:UTILity:BRATe ................................................................. 130
:UTILity:SBIT ..................................................................... 131
:UTILity:PARity .................................................................. 131
:UTILity:TIME ................................................................... 132
:UTILity:KNOB ................................................................. 132
:UTILity:SPEaker ............................................................... 133
:UTILity:ALARm ............................................................... 133
:UTILity:UNReg ................................................................. 134
:UTILity:GNG .................................................................... 134
:UTILity:CONTrast ........................................................... 135
:UTILity:BRIGhtness ......................................................... 135
:UTILity:LANGuage .......................................................... 135
:UTILity:SYSTem?
Set
Query
Description Returns the manufacturer,model, serial number
and firmware version number.
Query Syntax :UTILity:SYSTem?
Return parameter model name, serial
number, firmware version
Query example :UTILity:SYSTem?
>GW,PEL-3041,00000001,V1.01.010
Returns the system information.
:UTILity:LOAD
Set
Query
Description Sets or queries the Auto Load and Auto Load On
settings. This is equivalent to the settings in the
Shift+UTILITY>Load menu.