GW Instek PEL-3000 Series Programming Manual - Manual (Page 84)

PEL-3000 Programming Manual
82
Query example :RESistance:L1?
> 0
Returns the “level1” conductance setting(MHO).
:RESistance:L2
Set
Query
Description Sets or queries the CR mode “level2” conductance.
This command is applicable to dynamic mode
only.
Note: A different value can be set for each current
range (High/Mid/Low).
Syntax :RESistance:L2 {[ MHO ] | MINimum |
MAXimum }
Query Syntax :RESistance:L2?
Parameter
“level2” conductance
value
MINIMUM or MIN Minimum conductance
level
MAXIMUM or MAX Maximum conductance
level
Return parameter Returns the “Level2”
conductance value.
Example :RESistance:L2 MIN
Sets the conductance value to the minimum.
Query example :RESistance:L2?
> 2.
Returns the “Level2” conductance setting.(MHO)
:RESistance:SET
Set
Query
Description Sets or queries the CR dynamic mode Set value
when the dynamic units are set to Percent.
This command is only applicable in dynamic
mode.