GW Instek PEL-3000 Series Programming Manual - Manual (Page 95)

COMMNAND OVERVIEW
93
Example :POWer:L1 MIN
Sets the power value to the minimum.
Query example :POWer:L1?
>10W
Returns the “Lewel1” power setting.
:POWer:L2
Set
Query
Description Sets or queries the CP mode “Level2” power. This
command is only applicable to dynamic mode.
Note: A different “Level2” value can be set to
different current ranges.
Syntax :POWer:L2 {[ W ] | MINimum | MAXimum }
Query Syntax :POWer:L2?
Parameter [ W ] “Level2” power value
MINIMUM or MIN Minimum power level
MAXIMUM or MAX Maximum power level
Return parameter Returns the “Level2”
power value.
Example :POWer:L2 MIN
Sets the power value to the minimum.
Query example :POWer:L2?
>10W
Returns the “Level2” power setting.
:POWer:SET
Set
Query
Description Sets or queries the CP dynamic mode Set value
when the dynamic units are set to Percent.
This command is only applicable in dynamic
mode.
Syntax :POWer:SET {[ W ] | MINimum | MAXimum }
Query Syntax :POWer:SET?