GW Instek PEL-3000 Series Programming Manual - Manual (Page 91)

COMMNAND OVERVIEW
89
Voltage Subsystem Commands
:VOLTage[:VA] ..................................................................... 89
:VOLTage:VB ....................................................................... 89
:VOLTage[:VA]
Set
Query
Description Sets or queries the CV mode “A Value” voltage or
the +CV voltage value. Note: The same value
applies for each current range (High/Mid/Low).
Note: The optional command node [:VA] can only be
omitted when in static mode.
Syntax :VOLTage[:VA] {[ V ] | MINimum | MAXimum }
Query Syntax :VOLTage[:VA]?
Parameter [ V ] “A Value” voltage value
MINIMUM or MIN Minimum voltage level
MAXIMUM or MAX Maximum voltage level
Return parameter Returns the “A Value”
voltage value.
Example :VOLTage:VA MIN
Sets the voltage value to the minimum.
Query example :VOLTage:VA?
>1.000V
Returns the “A Value” voltage setting.
:VOLTage:VB
Set
Query
Description Sets or queries the CV mode “B Value”. Note: The
same value applies for each current range
(High/Mid/Low).
Syntax :VOLTage:VB {[ V ] | MINimum | MAXimum }
Query Syntax :VOLTage:VB?