GW Instek PEL-3000 Series Programming Manual - Manual (Page 126)

PEL-3000 Programming Manual
124
Parameter Parameters in order: Description
Current step number
Total number of steps
Value
|OFF|ON TRIG OUT setting
Return parameter Returns the settings for
the Data Edit for Fast
Sequence menu:
Step:/,
Value:, TRIG
OUT:ON|OFF
Example :FSEQuence:EDIT 4,11,0.1,OFF
Configures the Data Edit for Normal Sequence menu
to the settings shown below.
Query example :FSEQuence:EDIT?
> Step:0004/0011; Value:0.10000, TRIG OUT:OFF
:FSEQuence:EDIT:POINt
Set
Query
Description Sets or queries the current point in the sequence.
Syntax :FSEQuence:EDIT:POINt {}
Query Syntax :FSEQuence:EDIT:POINt?
Related
Commands :FSEQuence:EDIT:END?
Parameter/
Return parameter 1~1000*. The current point in the
sequence. *Depends on the number
of steps in the sequence.
Example :FSEQuence:EDIT:POINt 10
Sets the current point to 10.
Query example :FSEQuence:EDIT:POINt?
>10
Returns the current point in the sequence.