GW Instek PEL-3000 Series Programming Manual - Manual (Page 50)

PEL-3000 Programming Manual
48
[:CONFigure]:CRUNit
Set
Query
Description Sets or queries the CR mode setting units.
Syntax [:CONFigure]:CRUNit {OHM|MHO}
Query Syntax [:CONFigure]:CRUNit?
Parameter/
Return parameter OHM Set the units to ohms.
MHO Set the units to mho
(conductance)
Example :CRUNit OHM
Sets the CR mode units to ohms.
Query example :CRUNit?
>OHM
The CR mode units are ohms.
:CONFigure:DYNamic
Set
Query
Description Sets the display units for when dynamic mode
switching is used. Units can be selected from
Percent and Value. See the user manual for further
details. This command will also configure whether
to switch between each level using timers or a set
duty cycle.
Syntax :CONFigure:DYNamic { VALue | PERCent | TIME |
FDUTy }
Query Syntax :CONFigure:DYNamic?
Parameter VALUE or VAL Set the units to Value.
PERCENT or PERC Set the units to Percent.
TIME Use timers for timing.
FDUTY or FUDT Use duty cycle for timing.
Return parameter Return a string containing
the unit mode and the
timing mode.
Example :CONFigure:DYNamic VALue
Sets the dynamic mode units to value.