GW Instek PEL-3000 Series Programming Manual - Manual (Page 56)

PEL-3000 Programming Manual
54
Parallel Commands
[:CONFigure]:PARallel ........................................................ 54
[:CONFigure]:PARallel
Set
Query
Description Configures the unit for parallel operation, or
queries its state. This command configures the unit
as a Master or Slave, and configures how many
slave units are connected if the unit is configured
as a master.
Note The booster (PEL-3211) cannot use low current
range.
Syntax [:CONFigure]:PARallel { OFF | MASTer | SLAVe
|P2|P3|P4|P5|B1|B2|B3|B4 }
Query Syntax [:CONFigure]:PARallel?
Parameter P2,P3,P4 or P5
B1,B2,B3 or B4 Number of connected
slaves
Number of connected
booster
OFF Turn parallel mode off
MASTER or MAST Sets the unit to Master
SLAVE or SLAV Sets the unit to Slave
Return parameter Returns an ASCII string
with the mode of the unit
(Master/Slave) and the
number of connected
devices.
Example :PARallel MAST
Sets the unit to Master.
:PARallel B2
Configures the unit for use with 2 booster units.