GW Instek PEL-3000 Series Programming Manual - Manual (Page 53)

COMMNAND OVERVIEW
51
Return parameter Returns the delay time in
seconds.
Example :GNG:DTIMe 0.5
Sets the delay time to 0.5 seconds.
Query example :GNG:DTIMe?
>0.5
The delay time is 0.5 seconds.
[:CONFigure]:GNG:MODE
Set
Query
Description Sets or queries the entry mode for the Go-NoGo
settings. The entry mode determines whether the
Go-NoGo limits are set as values or as a
percentage value from a center reference value.
Syntax [:CONFigure]:GNG:MODE {PERCent | VALue }
Query Syntax [:CONFigure]:GNG:MODE?
Parameter PERCENT or PERC Sets the entry mode to %.
VALUE or VAL Sets the entry mode to
value
Return parameter Percent % entry mode
Value Value entry mode
Example :GNG:MODE PERCent
Sets the entry mode to %.
Query example :GNG:MODE?
>Percent
The entry mode is %.
[:CONFigure]:GNG[:PASS]
Set
Query
Description Queries the Go-NoGo test result(s). This command
can be used for all test modes (CC, CV, CR, CP).
Query Syntax [:CONFigure]:GNG[:PASS]?
Return parameter NG No Go (fail)
GO Go (Pass)