GW Instek PEL-3000 Series Programming Manual - Manual (Page 120)

PEL-3000 Programming Manual
118
Example :FSEQuence:STATe ON
Turns “Fast Sequence” on.
Query example :FSEQuence:STATe?
>OFF
“Fast Sequence” is off.
:FSEQuence
Set
Query
Description Configures the parameters for the Fast Sequence.
This remote command is equivalent to all the
settings in the “Timing Edit for Fast Sequence”
menu when entering the FUNC>Sequence>Fast
Sequence menu.
Syntax :FSEQuence {,CC|CR,
ILVL|IMVL||IHVL|ILVH|IMVH|IHVH,
|INFinity,,|OFF|ON,,
}
Query Syntax :FSEQuence?
Related
Commands :FSEQuence:STATe
Parameter Parameter in order: Description
Memo message. (Need to
enclose in quotes)
CC|CR Mode
ILVL|IMVL|IHVL|ILVH|
IMVH| IHVH Range
|INFinity Number of loops
Time base in seconds
ON|OFF Last Load 0=Off, 1=On.
Sets the load condition
after the end of the
sequence.
Last value: Sets the value
of the load condition for
Last Load = On
Repeat Step from
(0001~1000) per loop