GW Instek PEL-3000 Series Programming Manual - Manual (Page 111)

COMMNAND OVERVIEW
109
:NSEQuence
Set
Query
Description Configures the parameters for the Normal
Sequence. This remote command is equivalent to
the all the settings in the “Timing Edit for Normal
Sequence” menu when entering the
FUNC>Sequence>Normal Sequence menu.
Syntax :NSEQuence
{ ,,,CC|CR|CV|CP,ILVL|IMVL|IH
VL|ILVH|IMVH|IHVH,|INFinity,|OFF|ON
,,|OFF}
Query Syntax :NSEQuence?
Related
Commands :NSEQuence:STATe
Parameter Parameter in order: Description
Starting sequence number
Current sequence number
Memo message. (need to
enclose in quotes)
CC|CR|CV|CP Mode
ILVL|IMVL|IHVL|ILVH|IMV
H|IHVH Range
|INFinity Sets the loop number
|ON|OFF Last Load 0=Off, 1=On.
Sets the load condition
after the end of the
sequence.
Last value: Sets the value
of the load condition if
Last Load = On
|OFF Chain: Sets the next
sequence in the chain.