GW Instek PEL-3000 Series Programming Manual - Manual (Page 109)

COMMNAND OVERVIEW
107
Query example :CHAin?
>P1->P4;P2->Off;P3->Off;P4->P5;P5->P6;P6->Off;
P7->Off;P8->Off;P9->Off;P10->Off;P11->Off;
P12->Off;P13->Off;P14->Off;P15->Off;P16->Off
Returns the program chain configuration.
[:PROGram]:CHAin:P2P
Set
Query
Description Sets or queries a single link in the program chain.
Syntax [:PROGram]:CHAin:P2P {,|OFF}
Query Syntax [:PROGram]:CHAin:P2P? {P1|P2|P3|P4|P5|P6|P7|P8|P9
|P10|P11|P12|P13|P14|P15|P16}
Parameter Parameters in
order: Description
(1~16) Program number of single link.
|OFF (1~16) Program number that follows.
Query Parameter P1 ~ P16 The program number of the first link
of the chain that you are inquiring
about.
Return Parameter PX->PX|Off Returns the program number that
follows or Off.
Example :CHAin:P2P 4,6
Configures the program number 6 to follow after
program number 4:
P04→P06
Query example :CHAin:P2P? P4
>P4->6
Indicates that program 6 follows from program 4 in
the chain.
[:PROGram]:CHAin[:RECall]:DEFault
Set
Description Recalls the default settings for the program chain.
Syntax [:PROGram]:CHAin[:RECall]:DEFault
Example :CHAin:DEFault