Resistance subsystem commands, Resistance[:va – GW Instek PEL-3000 Series Programming Manual User Manual
Page 81
COMMNAND OVERVIEW
79
Resistance Subsystem Commands
:RESistance[:VA] .................................................................. 79
:RESistance:VB ..................................................................... 80
:RESistance:SRATe .............................................................. 80
:RESistance:L1 ...................................................................... 81
:RESistance:L2 ...................................................................... 82
:RESistance:SET ................................................................... 82
:RESistance:LEVel ............................................................... 83
:RESistance:RISE ................................................................. 84
:RESistance:FALL ................................................................ 84
:RESistance:T1 ...................................................................... 85
:RESistance:T2 ...................................................................... 86
:RESistance:FREQuency ..................................................... 86
:RESistance:DUTY ............................................................... 87
:RESistance[:VA]
Set
Query
Description
Sets or queries the CR mode “A Value” resistance.
This command is only applicable to static mode.
Note: A different value can be set for each current
range (High/Mid/Low).
Note: The optional command node [:VA] can only be
omitted when in static mode.
Syntax
:RESistance[:VA] {
MAXimum }
Query Syntax
:RESistance[:VA]?
Parameter
“A Value” conductance
value
MINIMUM or MIN
Minimum conductance
level
MAXIMUM or MAX
Maximum conductance
level
Return parameter
Returns the “A Value”
resistance value.