GW Instek PEL-3000 Series Programming Manual - Manual (Page 149)

COMMNAND OVERVIEW
147
Syntax :STATus:OPERation:PTRansition
Query Syntax :STATus:OPERation:PTRansition?
Parameter/
Return Parameter Condition Condition
1 CAL All other
bits Not used
32 WTG
Example :STATus:OPERation:PTRansition 32
Configures the WTG bit (Bit 5) in the Operation Status
Condition register to set the corresponding bit in the
Operation Status Enable register on a positive
transition.
Query example
:STATus:OPERation:PTRansition?
>32
The WTG bit is configured to PTR in the Operation
Status PTR filter.
:STATus:CSUMmary:CONDition?
Set
Query
Description Returns the status of the CSummary Status
Condition register. See page 153 for details.
Query Syntax :STATus:CSUMmary:CONDition?
Return parameter Condition Condition
1 CC 256 PRUN
2 CR All other
bits Not used
4 CV
8 CP
Query example :STATus:CSUMmary:CONDition?
>1
Indicates the unit is in CC mode.
:STATus:CSUMmary:ENABle
Set
Query
Description Sets which events are enabled in the CSummary
Status Enable register. The mask values are the bit
weights of the events. See page 153 for details.