GW Instek PEL-2000 Series Programming User Manual - Manual (Page 9)

INTERFACE OVERVIEW
9
5. Edit the Baud rate, Stop bit and
parity.
Baud rate 2400, 4800, 9600, 19200, 38400
Stop Bit Range 1,2
Parity Range None, Odd, Even
6. Connect the RS-232C cable to the
rear panel port: DB-9 male
connector.
RS232C
Terminal
application Invoke a terminal application such as MTTTY
(Multi-Threaded TTY).
 For RS-232C, set the COM port, baud rate, stop
bit, data bit, and parity accordingly.
To check the COM port No. for RS-232C, see the
Device Manager in the PC. For WinXP, Control
panel → System → Hardware tab.
7. Ensure the terminal application has the
following settings;
8. Baud rate – as per PEL-2000 settings
9. Com Port – as per PC settings (Device
Manager)
10. Parity – None
11. Data bits – 8
12. Stop bits – None