GW Instek PEL-2000 Series Programming User Manual - Manual (Page 5)

INTERFACE OVERVIEW
5
I
NTERFACE OVERVIEW
This manual describes how to use the PEL-2000’s
remote command functionality and lists the
command details. The Overview chapter describes
how to configure the PEL-2000 USB/RS232/GPIB
remote control interface.
Rear Panel Overview
PEL-2004
AWG 24
STRIP GAUGE 10.0 mm
1
CH CONT 1
1
CH CONT 2
1
CH CONT 3
1
CH CONT 4
1
CH CONT 5
1
CH CONT 6
1
CH CONT 7
1
CH CONT 8
SER. NO. LB
2
1
FRAME CONT
GO / NG OUTPUT GPIB
RS232C
DISCONNECT POWER CORD BEFORE REPLACING FUSE
50/60 Hz 180 VA MAX
AC
250V T 3.15A
REPLACE FUSE
115V 230V
FUSE RATING AS SPECIFIED
WARNING
TO AVOID ELECTRIC SHOCK THE POWER CORD PROTECTIVE
DO NOT REMOVE COVERS. REFER SERVICING TO QUALIFIED PERSONNEL.
250V FUSE OF THE SPECIFIED TYPE AND RATING. FOR CONTINUED FIRE PROTECTION. REPLACE FUSE ONLY WITH
NO OPERATOR SERVICEABLE COMPONENTS INSIDE.
GROUNDING CONDUCTOR MUST BE CONNECTED TO GROUND.
Go/NoGo
Output
GPIB
RS232C
USB-B
terminal
USB-A
terminal
Frame Control 1,2
Power switch,
Power Socket, Fuse Channel
Control, 1~8
PEL-2002
GROUNDING CONDUCTOR MUST BE CONNECTED TO GROUND.
NO OPERATOR SERVICEABLE COMPONENTS INSIDE.
FOR CONTINUED FIRE PROTECTION. REPLACE FUSE ONLY WITH 250V FUSE OF THE SPECIFIED TYPE AND RATING.
DO NOT REMOVE COVERS. REFER SERVICING TO QUALIFIED PERSONNEL.
TO AVOID ELECTRIC SHOCK THE POWER CORD PROTECTIVE
WARNING
AS SPECIFIED
FUSE RATING
230V 115V
REPLACE FUSE
T 3.15A 250V
AC
120 VA MAX 50/60 Hz
BEFORE REPLACING FUSE DISCONNECT POWER CORD
RS232C
GPIB GO / NG OUTPUT
FRAME CONT
1
2
SER. NO. LB
CH CONT 4
1
CH CONT 3
1
CH CONT 2
1
CH CONT 1
1
10.0 mm STRIP GAUGE
AWG 24
Power switch,
Power Socket, Fuse
Channel
Control, 1~4
Go/NoGo
Output
GPIB
RS232C
USB-B
terminal
USB-A
terminal
Frame Control 1,2