GW Instek PEL-2000 Series Programming User Manual - Manual (Page 135)

COMMAND DETAILS
135
Power Subsystem
:POWer:L1/L2 ............................................................... 135
:POWer:CURRent ......................................................... 136
:POWer:RECall .............................................................. 137
:POWer:LOW:AVALue/BVALue .................................. 137
:POWer:LOW:CURRent ............................................... 138
:POWer:HIGH:AVALue/BVALue ................................ 139
:POWer:HIGH:CURRent .............................................. 140
:POWer:L1/L2
Channel Specific
Command
Description Sets the A/B Value for constant power mode,
where L1 is A Value and L2 is B Value. The
command is range dependant. If the current range
is Low, then the command will only apply to the
low range settings.
Syntax :POWer:L1|L2 [W]
Parameter [W]
L1 1 Sets A Value to 1 Watt.
L2 2 Sets B Value to 2 Watts.
L1 1W Sets A Value to 1 Watt.
(single channel only)
L1 MIN Sets A Value to the
minimum level for the
specific channel.
L1 MAX Sets A Value to the
maximum Level for the
specific channel.
Example :POW:L1 1 Sets A Value to 1 watt
Query Syntax :POW:L1?/L2? [MAX|MIN]
Return Parameter [MAX|MIN] Current