GW Instek PEL-2000 Series Programming User Manual - Manual (Page 11)

INTERFACE OVERVIEW
11
GPIB Interface Configuration
Panel operation 1. Press the Shift Key then the Help
key to access the Utility menu.
UTILITY
HELP SHIFT
2. Press F3(Interface Menu).
F3
3.
03/02/09
10 : 30
O
GPIB Interface
Configure Other
System
Info
Interface Time Set Load
Address
01
GPIB
4. If the interface is not set to GPIB,
use the selector knob to change
the interface to GPIB.
5. Edit the GPIB address.
Range 1 ~ 30
6. Connect the GPIB cable to
the rear panel port: 24-pin
female connector