GW Instek PEL-2000 Series Programming User Manual - Manual (Page 6)

PEL-2000 Programming Manual
6
Configuring the USB Interface
USB connection PC side connector Type A, host
PEL-2000 side
connector Type B, device
Speed 1.1/2.0 (full speed)
Panel operation 1. Press the Shift Key then the Help
key to access the Utility menu.
UTILITY
HELP SHIFT
2. Press F3(Interface Menu).
F3
3.
03/02/09
10 : 30
O
USB Interface
Configure Other
System
Info
Interface Time Set Load
USB
4. If the interface is not USB, use the
selector knob to choose USB.
5. Connect the USB cable to the
USB-B slave port on the rear.
6. When the PC asks for the USB driver, select
pel_cdc_2000.inf (downloadable from the GW
website,
www.gwinstek.com , PEL-2000 product
corner).