GW Instek PEL-2000 Series Programming User Manual - Manual (Page 107)

COMMAND DETAILS
107
Example :RES:STAT:LOW:RISE 0.1 Sets the rising slew rate
to 0.1A/uS.
Query Syntax :RESistance:STATic:LOW:RISE/FALL? [MIN|MAX]
Return Parameter [MAX|MIN] Slew rate
1 Unit =1 amp/uS Returns the slew rate.
MAX, MIN Returns the allowable
maximum and minimum.
Query Example :RES:STAT:LOW:RISE?
MAX
0.8000 For low range CR mode,
the maximum value for
the rising slew rate is 0.8
A/uS for the specific
channel.
:RESistance:STATic:HIGH:AVALue/BVALue
Channel Specific
Command
Description Sets the high range A/B Value for constant
resistance static mode.
Syntax :RESistance:STATic:HIGH:AVALue/BVALue
[OHM]
Parameter NRf+[OHM]
AVALue 10 Sets A Value to 10 ohms.
(high range only)
BVALue 20OHM Sets B Value to 20 ohms.
(high Range only)
AVALue MIN Sets A Value to the
minimum level for the
specific channel.
AVALue MAX Sets A Value to the
maximum level for the
specific channel.
Example :RES:STAT:HIGH:BVAL 10 Sets high range CR static
mode B Value to 10
ohms.